Holiday Lights, Space Heaters and Tripped Breakers: A Colorado Homeowner's Guide


The roaster is going, the porch lights are glowing, and a space heater is warming the guest room. Then half the kitchen goes dark.
A tripped breaker during the holidays is common, and usually it's your electrical system doing its job. Here's what's really going on inside your panel, how to reset a breaker safely, and when it's worth calling an electrician.
Why Breakers Trip More Around the Holidays
Each circuit can safely carry a limited amount of electricity. When it's asked to carry more, the breaker shuts it off before the wires overheat.
The holidays pile extra demand onto the same circuits: roaster ovens and coffee makers on the kitchen counter, space heaters in chilly rooms, and light displays outside. Colorado adds a twist. A Front Range cold snap sends everyone reaching for a space heater, and snow and melting ice can trip outdoor outlets.
How Many Watts Does a Space Heater Use?
Space heaters are labeled in watts. Breakers are rated in amps. To connect the two, divide watts by 120 volts, the standard household voltage:
Watts ÷ 120 = amps
Most plug-in space heaters top out at 1,500 watts on high. That works out to about 12.5 amps. On low, many run around 750 watts, or roughly 6 amps.
Most bedroom and living room outlets are on 15-amp or 20-amp circuits. For anything that runs for hours at a time, like a heater, electricians plan around 80% of the breaker's rating:
Circuit | Breaker rating | Comfortable continuous load |
15-amp | 1,800 watts | About 1,440 watts (12 amps) |
20-amp | 2,400 watts | About 1,920 watts (16 amps) |
At about 12.5 amps, a heater on high is already at or slightly over that comfortable limit on a 15-amp circuit by itself. That's why it works best on a circuit of its own, or alongside only small loads like a lamp or phone charger.
What can share a circuit with a space heater?
Wattages vary by model, so check the label on the bottom or back of each appliance. As a general guide:
Usually fine: LED lamps, phone chargers, a Wi-Fi router, a laptop
Likely to trip a 15-amp circuit: a hair dryer, toaster, microwave, coffee maker, vacuum, or a second heater
Running the heater on low cuts its draw roughly in half, which can be enough to keep the breaker from tripping.
Why the Breaker Trips 20 Minutes Later
Here's something most homeowners don't know: a typical breaker has two ways of tripping.
Instantly, for a big surge, like a short circuit. If a breaker trips the moment you flip it back on or plug something in, that points to a short or a damaged cord or appliance, and it's worth calling an electrician.
Slowly, for a modest overload. Inside the breaker, a small strip of metal heats up as extra current passes through it and gradually bends until it trips. That's why the heater can run fine for 15 or 20 minutes, someone starts the hair dryer, and then everything goes dark. The heater isn't broken. The circuit was simply asked to carry more than it was built for, for long enough to matter.
How to Reset a Tripped Breaker Safely
Lighten the load. Unplug or turn off what was running on that circuit.
Find the tripped breaker. It will sit in the middle or toward "off," out of line with the others.
Push it fully to "off," then back to "on."
Plug things back in a few at a time, moving high-draw appliances to other circuits.
Not sure which outlets share a circuit? They often span more than one room. A bedroom might share a circuit with the hallway or even a bathroom. Plug a lamp into an outlet, switch off one breaker at a time, and note what goes dark. Labeling your panel now saves a scramble later.
When to stop: If the breaker trips again right away, feels hot, or you smell burning, leave it off and call an electrician. Never swap in a larger breaker. It's sized to protect the wire in your walls, not the appliance.
Space Heater Safety
Plug it directly into a wall outlet, never an extension cord or power strip.
Give it a circuit to itself when you can.
Keep three feet of clear space from curtains, bedding, furniture and decorations.
Choose one with tip-over and overheat shutoff, and turn it off when you leave the room or go to sleep.
A warm plug is a warning sign. A heater pulls steady power for hours, which exposes worn outlets. When the metal contacts inside an older outlet loosen, they grip the plug poorly, and that weak connection creates heat. If the plug feels hot, fits loosely or the outlet looks discolored, stop using that outlet and have it replaced.
Relying on a space heater every winter?
If one room needs a heater all season to feel livable, the real issue is often heat escaping through thin attic insulation or hidden air leaks. Read why your house feels drafty, or book a free Energy Efficiency Assessment & Quote. We'll check your attic insulation and ventilation, run a blower door test, and give you a quote for recommended upgrades.
Holiday Lights and Kitchen Tips
Inspect light strings for broken sockets and frayed wires, and toss damaged ones.
Switch to LED. LED strings use a small fraction of the power of older incandescent lights, so you can run far more of them on one circuit.
Use outdoor-rated lights and cords outside, plugged into GFCI-protected outlets.
Keep connections off wet ground. A GFCI outlet shuts off power when it senses a tiny leak to ground, about 5 thousandths of an amp. That's far below anything a breaker would notice, and it's why a plug sitting in melting snow can trip it.
Secure lights against Front Range wind with insulated clips, not nails or staples.
Spread out kitchen appliances. Newer kitchens have at least two 20-amp countertop circuits, but older homes may have fewer. A roaster oven can draw around 1,400 watts on its own. Add a 1,000-watt coffee maker on the same circuit and you're at 2,400 watts, the full limit of a 20-amp breaker.
When to Call an Electrician
An occasional trip on a busy holiday isn't cause for worry. These signs are worth a call:
A breaker that trips often, even with a normal load
Warm outlets or switch plates, scorch marks, or a burning smell
Lights that dim or flicker when an appliance turns on
Too few outlets, or a panel with no room for new circuits
A breaker that trips instantly when reset
Sometimes the fix is a new outlet or a dedicated circuit. Other times the panel itself is the limit, especially if you're also planning an EV charger or a remodel. Our licensed electricians offer electrical services across the Front Range, from tracking down recurring trips to a full panel upgrade.
Frequently Asked Questions
How many amps does a space heater use?
A typical 1,500-watt space heater draws about 12.5 amps on high and roughly 6 amps on low. To figure any appliance's amps, divide its wattage by 120.
How many watts can a 15-amp circuit handle?
A 15-amp circuit is rated for 1,800 watts. For something that runs for hours, like a space heater, plan on about 1,440 watts, which is 80% of the rating.
What can I plug in on the same circuit as a space heater?
Low-draw items like LED lamps, phone chargers and a laptop are usually fine. Avoid hair dryers, microwaves, toasters, coffee makers, vacuums and a second heater on the same circuit.
Why does my space heater keep tripping the breaker?
A 1,500-watt heater uses most of a 15-amp circuit on its own, so adding almost anything else can overload it. Breakers react slowly to small overloads: a heat-sensing strip inside warms up over several minutes before it trips, which is why the heater may run fine for a while first. Move the heater to a circuit with nothing else running, or use the low setting. If it trips with nothing else plugged in, have an electrician check the circuit.
Why does my breaker keep tripping?
There are three common reasons. An overload means too much is running on one circuit. A short circuit means a wire, cord or appliance is damaged, and the breaker usually trips instantly. A ground fault means electricity is leaking to ground, often through moisture. Overloads can be fixed by spreading out the load. Instant or repeated trips with little running deserve an electrician's look.
Is it dangerous when a breaker trips?
No. A trip is a safety feature working as designed. The concern is when it happens often, trips instantly, or comes with warm outlets, burning smells or scorch marks.
Can I use an extension cord or power strip with a space heater?
It's best not to. Most power strips and household extension cords aren't built for a heater's steady, high draw, and they can overheat. Plug the heater directly into a wall outlet.
Why does my GFCI keep tripping?
A GFCI outlet shuts off when it senses a very small leak to ground. Moisture is the most common cause, which is why outdoor outlets running holiday lights often trip after snow or rain. Damaged light strings, a worn appliance cord, or an aging GFCI outlet can also cause repeated trips. If it keeps happening in dry weather with nothing plugged in, have the outlet checked.
Enjoy the Season With Fewer Surprises
A tripped breaker over Thanksgiving dinner is usually a sign to spread things out, not a reason to panic. If your home keeps running short on power when you need it most, our electricians are happy to take a look.
Have a question first? Contact Colorado Home Services
Rebate programs, tax incentives, eligibility requirements and equipment qualifications are subject to change. Confirm current program requirements and available incentives before making a purchasing decision.
![colorado-home-services-logo[1].png](https://static.wixstatic.com/media/6b37c4_fdeb15acb4d043e2b986abc5a182e022~mv2.png)



Comments